Lotus Clean pH-Plus Granulat

Instructions:

There are no general dosing quantities for raising the pH value, as this depends on the water hardness.

First measure the pH value of the water. Now switch on the pumps. Add one teaspoon of pH-Plus granulate per 1,000 litres of water content to the water by letting the granulate trickle slowly into the water near the filter. The pumps should then run for two to three minutes. Now measure the pH value again. Based on the measured increase in pH, you can estimate how much pH-Plus granulate you still need.

Caution: Never add too much pH-Plus Granulate to the water at once. This can lead to an immediate build-up of limescale and cloud the water. If this happens, lower the pH value to a value of 6.5. Then wait one to two days until the water is clear again.